Frequency Characteristics |
| JDS6600-15M | JDS6600-30M | JDS6600-40M | JDS6600-50M | JDS6600-60M |
Sine frequency range | 0~15MHz | 0~30MHz | 0~40MHz | 0~50MHz | 0~60MHz |
Square frequency range | 0~15MHz | 0~15MHz | 0~15MHz | 0~15MHz | 0~15MHz |
Triangle frequency range |
Pulse frequency range | 0~6MHz | 0~6MHz | 0~6MHz | 0~6MHz | 0~6MHz |
CMOS/TTL digital frequency range |
Arbitrary wave frequency range |
Square rise time | ≤30nS | ≤25nS | ≤20nS | ≤20nS | ≤20nS |
Mininum Frequency resolution | 0.01µHz(0.00000001Hz) |
Frequency accuracy | ±20ppm |
Frequency stability | ±1ppm/3h |
Waveform Characteristics |
Waveform | Sine, Square, Triangle, Pulse (duty-cycle correction),Partia Sine, CMOS, DC level, Half-wave, Full-Wave, Pos-Ladder, Neg-Ladder, Noise, Exponential Rise, Exponential Fall, Tone, Sinc Pulse, Lorentz Pulse, and 60 kinds user defined waveform. |
Waveform length | 2048 points |
Waveform sampling rate | JDS6600-15M | JDS6600-30M | JDS6600-40M | JDS6600-50M | JDS6600-60M |
200MSa/s | 266MSa/s |
Waveform vertical resolution | 12 bits |
Sine | Harmonic suppression | ≥45dBc(<1MHz); ≥40dBc(1MHz~20MHz) |
Total harmonic distortion | <0.8%(20Hz~20kHz,0dBm) |
Square and Pulse | Overshoot (Square) | ≤5% |
Duty-cycle range(Pulse) | 0.1%~99.9% |
Ramp wave | Linearity | ≥98%(0.01Hz~10kHz) |
Output Characteristics |
Amplitude range | JDS6600-15M | JDS6600-30M | JDS6600-40M | JDS6600-50M | JDS6600-60M |
≤10MHz:2mVpp~20Vpp ≤15MHZ:2mVpp~10Vpp | ≤10MHz:2mVpp~20Vpp ≤30MHZ:2mVpp~10Vpp | ≤10MHz:2mVpp~20Vpp ≤30MHZ:2mVpp~10Vpp ≤60MHZ:2mVpp~5Vpp |
Amplitude resolution | 1mV |
Amplitude stability | ±0.5%/5 h |
Amplitude flatness | ±5%(<10MHz); ±10%(>10MHz) |
Waveform Output |
Output impedance | 50Ω±10%(typical) |
Protection | All the signal output termianl can be shorted within 60s |
DC Offset |
Offset adjusting range | Output Amplitude >2V | 0.2V | 0 |
-9.99V~9.99V | -2.5V~2.5V | -0.25V~0.25V |
Offset resolution | 0.01 V |
Phase characteristics |
Phase adjusting range | 0~359.9° |
Phase resolution | 0.1° |
TTL/COMS Output |
Low level | <0.3V |
High level | 1V~10V |
Level rise/fall time | ≤20ns |
External Measurement Function |
Frequency meter function | Frequency measurement range | 1Hz~100MHz |
Measurement accuracy | Gate time continuously adjusted between0.01s~10s |
Counter function | Counting region | 0-4294967295 |
Coupled mode | 2kinds Coupling modes, DC and AC |
Control mode | Manual operation |
Input signal voltage range | 2Vpp~20Vpp |
Pulse width measurement | 0.01us (resolution), 20s (MAX measuring time) |
Period measurement | 0.01us (resolution), 20s (MAX measuring time) |
Sweep Function |
Sweep channel | CH1 or CH2 |
Sweep type | linear sweep, log sweep |
Sweep time | 0.1s~999.9s |
Setting range | User settings |
Sweep direction | Forward, Backward and Roundtrip |
Burst function |
Number of pulses | 1-1048575 |
Burst mode | Manual Trig, CH2 Trig, Ext.Tring(AC), Ext.Tring(DC) |
Technical parameters |
Display | Display type | 2.4 inch TFT color LCD |
Storage and loading | Quantity | 100 groups |
Location | 00 to 99(Power on will load the position 00) |
Arbitrary wave | quantity | 1 to 60, totally 60 groups(default set 15 groups) |
Interface | Interface mode | USB to serial interface |
Extension interface - | There is serial interface of TTL level mode to be convenient for user development. |
Communication speed | 115200bps |
communication protocol | Open protocol |
Power supply | Voltage range | DC5V±0.5V |
Manufacturing process | Surface-mount technology, FPGA design, high reliability, long service life |
Buzzer | User can set ON or OFF by procedure |
Operating characteristics | Full button operation, knob continuous adjustment |
Environmental conditions | Temperature: 0~40 oCHumidity:<80% |